Installing The Clutch - Yamaha XVS1100(L) Service Manual

CLUTCH
EAS00295

INSTALLING THE CLUTCH

1. Install:
S clutch housing 1
NOTE:
S If the wire circlip 2 has been removed, care-
fully install a new one as shown.
2. Tighten:
S lock washer
New
S clutch boss nut 1
NOTE:
While holding the clutch boss with the clutch
holding tool 2 , tighten the clutch boss nut.
Clutch holding tool
90890-04086
3. Bend the lock washer tab along a flat side of
the nut.
4. Lubricate:
S long clutch push rod
S short clutch push rod
(with the recommended lubricant)
Recommended lubricant
Lithium soap base grease
5. Lubricate:
S friction plates
S clutch plates
(with the recommended lubricant)
Recommended lubricant
Engine oil
6. Install:
S friction plates
S clutch plates
S long clutch push rod
S short clutch push rod
S bearing
S washer
4-45
ENG
70 Nm (7.0 mSkg)