Yamaha XVS1100(L) Service Manual page 184

MIDDLE GEAR
2. Install:
S shim
S middle drive shaft assembly
3. Install:
S bearing retainer
Install steps:
S Attach the bearing retainer wrench 1 .
Bearing retainer wrench:
90890-04137
S Tighten the bearing retainer.
Bearing retainer:
110 Nm (11.0 mSkg)
S Lock the threads on the bearing retainer by
staking them with a center punch.
4. Adjust:
S middle gear backlash
Middle gear backlash:
0.1 X 0.2 mm
a. Install the universal joint holder 1 and
middle gear backlash band 2 as shown.
Universal joint holder
90890-04062
Middle gear backlash band
90890-01231
b. Make sure that the dial gauge plunger on the
middle gear backlash band as shown.
a Dial-gauge-plunger contact point: 68.2 mm
c. Remove the middle driven pinion gear nut
and apply the LOCKTITE on it.
d. Reinstall the middle driven pinion gear nut.
e. While measure the middle gear backlash,
tighten the middle driven pinion gear nut until
specific backlash.
4-79
ENG