Synchronizing The Carburetors - Yamaha XVS1100(L) Service Manual

ADJUSTING THE VALVE CLEARANCE/

SYNCHRONIZING THE CARBURETORS

Locknut:
27 Nm (2.7 mSkg)
e. Measure the valve clearance again.
f. If the valve clearance is still out of specifica-
tion, repeat all of the valve clearance adjust-
ment steps until the specified clearance is
obtained.
11. Install:
S all removed parts
NOTE:
Install all removed parts in the reverse order of
their disassembly. Note the following points.
S camshaft sprocket covers
S tappet covers
S spark plugs
EAS00051
SYNCHRONIZING THE CARBURETORS
NOTE:
Prior to synchronizing the carburetors, the valve
clearance and the engine idling speed should
be properly adjusted and the ignition timing
should be checked.
1. Stand the motorcycle on a level surface.
NOTE:
Place the motorcycle on a suitable stand.
2. Remove:
S rider's seat
S fuel tank
Refer to "FUEL TANK AND SEATS".
3. Remove:
S air duct 1
4. Remove:
S vacuum plugs 1
3-8
INSP
ADJ
10 Nm (1.0 mSkg)
10 Nm (1.0 mSkg)
20 Nm (2.0 mSkg)