CLUTCH
EAS00278
REMOVING THE CLUTCH
1. Straighten the lock washer tab.
2. Loosen:
S clutch boss nut 1
NOTE:
While holding the clutch boss 2 with the clutch
holding tool 3 , loosen the clutch boss nut.
Clutch holding tool
90890-04086
3. Remove:
S clutch boss nut 1
S lock washer 2
S clutch boss 3
NOTE:
There is a built-in damper between the clutch
boss 3 and the clutch plate 4 . It is not neces-
sary to remove the wire circlip 5 and disas-
semble the built-in damper unless there is seri-
ous clutch chattering.
EAS00281
CHECKING THE FRICTION PLATES
The following procedure applies to all of the fric-
tion plates.
1. Check:
S friction plate
Damage/wear ! Replace the friction plates
as a set.
2. Measure:
S friction plate thickness
Out of specification ! Replace the friction
plates as a set.
NOTE:
Measure the friction plate at four places.
Friction plate thickness
2.9 X 3.1 mm
<Limit>: 2.8 mm
4-42
ENG