Yamaha XVS1100(L) Service Manual page 208

FRONT WHEEL AND BRAKE DISCS
6-4
NOTE:
A tight spoke will emit a clear, ringing tone, a
loose spoke will sound flat.
4. Tighten:
S spokes
NOTE:
After tightening the spokes, measure the front
wheel runout.
5. Measure:
S front wheel radial runout 1
S front wheel lateral runout 2
Over the specified limits ! Replace.
Front wheel radial runout limit
1.0 mm
Front wheel lateral runout limit
0.5 mm
6. Check:
S collars
Damage/wear ! Replace.
WARNING
S New tires have a relatively low grip on the
road surface until they have been slightly
worn.
Therefore, approximately 100 km should
be traveled at normal speed before any
highspeed riding is done.
7. Check
S wheel bearings
Front wheel turns roughly or is loose ! Re-
place the wheel bearings.
S oil seals
Damage/wear ! Replace.
8. Replace:
S wheel bearings (New)
S oil seals (New)
CHAS
3 Nm (0.3mSkg)