Checking The Brake Discs - Yamaha XVS1100(L) Service Manual

FRONT WHEEL AND BRAKE DISCS
6-5
a. Clean the outside of the front wheel hub.
b. Remove the oil seals 1 with a flat-head
screwdriver.
NOTE:
To prevent damaging the wheel, place a rag be-
tween the screwdriver and the wheel surface.
c. Remove the wheel bearings with a general
bearing puller 2 .
d. Install the new wheel bearings and oil seals
in the reverse order of disassembly.
CAUTION:
Do not contact the wheel bearing center race
4 or balls 5 . Contact should be made only
with the outer race 6 .
NOTE:
Use a socket 3 that matches the diameter of
the wheel bearing outer race and oil seal.
EAS00531

CHECKING THE BRAKE DISCS

The following procedure applies to all of the
brake discs.
1. Check:
S brake disc
Damage/galling ! Replace.
2. Measure:
S brake disc deflection 1
Out of specification ! Correct the brake disc
deflection or replace the brake disc.
Brake disc deflection limit
(maximum)
Front: 0.15 mm
Rear: 0.15 mm
a. Place the motorcycle on a suitable stand so
that the wheel is elevated.
b. Before measuring the front brake disc deflec-
tion, turn the handlebar to the left or right to
ensure that the front wheel is stationary.
CHAS