Yamaha XVS1100(L) Service Manual page 260

HANDLEBAR
S Align the match marks b on the handlebar
with the upper surface of the lower handlebar
holders.
3. Install:
S throttle grip
S throttle cable
WARNING
Make sure that the pin a on the throttle
cable housing is aligned with the hole b in
the handlebar.
4. Install:
S master cylinder
Refer to "FRONT AND REAR BRAKES".
5. Install:
S clutch lever holder 1
NOTE:
Align the slit in the clutch lever holder with the
punch mark a in the handlebar.
6. Install:
S left handlebar switch 1
NOTE:
Aligh the matching surface on the handlebar
switches with the punch mark a on the handle-
bar.
7. Install:
S clutch cable
8. Connect:
S clutch switch coupler
NOTE:
Apply a thin coat of lithium soap base grease
onto the end of the clutch cable.
6-56
CHAS