SHAFT DRIVE
5. Install:
S collar 1
S oil seal 2
New
S bearing
(with an appropriate press tool 3 and press)
NOTE:
The bearing can be reused, but Yamaha recom-
mends installing a new one.
EAS00726
ALIGNING THE FINAL DRIVE PINION GEAR
AND RING GEAR
NOTE:
Aligning the final drive pinion gear and ring gear
is necessary when any of the following parts are
replaced:
S Final drive housing
S Any bearing
1. Select:
S final drive pinion gear shim(-s) 1
S ring gear shim(-s) 2
a. Position the final drive pinion gear and the
ring gear with shims 1 and 2 . Calculate the
respective thicknesses from information
marked on the final drive housing and the
drive pinion gear.
1 Final drive pinion gear shim
2 Ring gear shim
3 Thrust washer
b. To find final drive pinion gear shim thickness
"A" use the following formula:
Final drive pinion gear shim thickness
A = (84 + a /100) – b
6-83
CHAS