Checking The Starter Clutch - Yamaha XVS1100(L) Service Manual

GENERATOR AND STARTER CLUTCH
4-50
NOTE:
S Remove the rotor by pushing back the rotor,
the flywheel puller 2 and the adapter 3 .
S Install the flywheel puller bolts and tighten the
center bolt, making sure that the tool body
stays parallel to the rotor. If necessary, one
holding bolt may be backed out slightly for re-
alignment of the tool.
S When rotor is removed, the dowel pins and
springs are scatter and dropping down. Do not
missing them.
Sheave holder:
90890-01701
Flywheel puller:
90890-01362
Adapter:
90890-04131
EAS00349

CHECKING THE STARTER CLUTCH

1. Check:
S starter clutch idle gear 1
S starter clutch drive gear 2
Burrs/chips/roughness/wear
the defective part(-s).
2. Check:
S starter clutch operation
a. When turning the starter clutch drive gear
counter clockwise b , the starter clutch and
the starter clutch drive gear should engage.
If the starter clutch drive gear and starter
clutch do not engage, the starter clutch is
faulty and must be replaced.
b. When turning the starter clutch drive gear
clockwise a , it should turn freely.
If the starter clutch drive gear does not turn
freely, the starter clutch is faulty and must be
replaced.
ENG
!
Replace