27
Purge hose (carburetor-solenoid
26
valve) (for California)
A Fasten the handlebar switch
leads (left and right) to the
handlebar with plastic locking
tie.
CABLE ROUTING
B Position the throttle cable and
starter cable as shown, and
clamp them with holder.
C Clamp the wire harness with
the hook of frame side.
D When installing the pipe of
throttle cables, press it inside.
E Connect the sensing hose
(carburetor joint-AIS side) with
a nozzle.
2-27
SPEC
F Push the wire harness inside
of the tool box plate.
G Route the sidestand lead
inside of engine cover.
H Position the all connectors
inside of the connector cover.
I Route the clutch cable through
the cable guide.