A Clamp the battery positive (+)
lead to the battery with battery
band.
B Connect the battery negative
(–) lead connector and push it
into the space between battery
box and battery.
C Route the rectifier / regulator
lead, wire harness and starter
motor positive (+) lead through
the outside of frame bracket
and fasten them to the frame
with a plastic locking tie.
CABLE ROUTING
D Connect the purge hose
(carburetor side-solenoid valve
side) with joint. (for California)
E Route the front turn signal light
lead and headlight lead through
the rear of headlight body hole.
F Connect the ignition coil lead at
red tape to the right side.
G Fasten the rear brake switch
lead to the brake switch bracket
with a plastic locking tie.
2-30
SPEC
H Fasten the rear brake switch
lead and master cylinder
reservoir hose to the down
tube with a plastic locking tie.
I Fasten the wire harness,
starter motor positive (+) lead
and battery negative (–) lead to
the frame with a plastic locking tie.
J Route the rectifier / regulator
lead and carburetor heater lead
through inside of battery box
hole to outside it and connect
them.
E