Disassembling The Middle Driven Shaft Assembly; Checking The Middle Drive Shaft Assembly - Yamaha XVZ13TF 1999 Service Manual

MIDDLE GEAR
EAS00437
DISASSEMBLING THE MIDDLE DRIVEN
SHAFT ASSEMBLY
NOTE:
The following procedure should only be per-
formed if the middle drive gear or middle driven
shaft bearing(-s) has to be replaced.
1. Remove:
S universal joint
a. Remove the circlips 1 .
b. Place the universal joint in a press.
c. With a pipe of the proper diameter positioned
deneath the universal joint driven yoke as
shown, press the bearing into the pipe.
NOTE:
It may be necessary to lightly tap the universal
joint driven yoke with a center punch.
d. Repeat the above steps to remove the oppo-
site side's bearing.
e. Separate the universal joint yokes.
2. Loosen:
S middle driven shaft nut
NOTE:
While holding the universal joint driven yoke
with the universal joint holder 1 , loosen the
middle driven shaft nut.
Universal joint holder
YM-04062, 90890-04062
EB414400
CHECKING THE MIDDLE DRIVE SHAFT AS-
SEMBLY
1. Check:
S damper cam surface
Scratches/wear ! Replace the damper
cam.
2. Check:
S spring
Cracks/damage ! Replace.
4-107
ENG