Character Commands - Ithaca PcOS Series 80PLUS Programmer's Manual

Programmer's Guide

Character Commands

Function
ASCII
Hexadecimal
Decimal
Range
Description
Function
ASCII
Hexadecimal
Decimal
Range
Description
PcOS Series 80PLUS
Set right-side character spacing
ESC SP
1BH 20H
<27> <32>
0 ≤ n ≤ 255
This command sets the character spacing for the right side of the character
to [n × horizontal motion unit]. When standard mode is selected, the
vertical motion unit set by GS P is used. When page mode is selected, the
vertical or horizontal motion unit set by GS P is used for the print
directions set by ESC T.
Select/cancel user-defined character sets
ESC %
1BH 25H
<27> <37>
See table below.
This command selects or cancels a user-defined character set as defined
below.
Hex Decimal Function
00 0 Selects Code Page 437 and turns off user defined
set
01 1 Selects user defined character set in the RAM buffer
02 2 Selects Code Page 850 and turns off user defined
set
41 65 Selects user defined character set in nonvolatile
EEPROM buffer
If the user defined character set in RAM is selected and the set does not
exist, an empty set will be created. Any user defined bit-image will be
erased. Any characters referenced that are not defined will be replaced as
follows: equivalent Code Page 437 character in Axiohm 7193 emulation
and equivalent current code page character in Epson TM-T8x emulation.
If the user defined character set in the nonvolatile EEPROM buffer is
selected and the set does not exist, this command will be ignored. (See the
GS ' command for saving a user defined character set in the RAM buffer to
the nonvolatile EEPROM buffer).
Rev B 4/13/99
Epson Commands
Command Descriptions
n
n
n
n
n
n
Table of n
[EA]
[EA]
Page 73