Ithaca PcOS Series 80PLUS Programmer's Manual page 97

Programmer's Guide
Function
ASCII
Hexadecimal
Decimal
Range
Description
Function
ASCII
Hexadecimal
Decimal
Range
Description
PcOS Series 80PLUS
The parameters for the horizontal or vertical motion units (x or y) differ
depending on the starting position of the printing area as follows:
If the starting position is the upper left or lower right of the printing area
(n = 0, 2, 48, or 50), then these commands use
1) Horizontal motion units, ESC SP, ESC $, and ESC \
2) Vertical motion units, ESC 3, ESC J, GS $, and GS \
If the starting position is the upper right or lower left of the printing area
(n = 1, 3, 49, or 51), then these commands use
1) Horizontal motion units, ESC 3, ESC J, GS $, and GS \
2) Vertical motion units, ESC SP, ESC $, and ESC \
Set absolute vertical print position in page mode
GS $
1DH 24H
<29> <36>
0 ≤ n ≤ 255
L
0 ≤ n ≤ 255
H
GS $ n n sets the absolute vertical print starting position for buffer
L H
character data in page mode to [(n
motion unit)] inches. This command is effective only in page mode.
Set absolute vertical print position in page mode
GS \
1DH 5CH
<29> <92>
0 ≤ n ≤ 255
L
0 ≤ n ≤ 255
H
GS \ n n moves the vertical print position in page mode to [(n
L H
256) × (vertical or horizontal motion unit)] inches from the current
position. This command is effective only in page mode. Use the
complement of N for setting pitch movement upward: -N pitch = 65536 -
× 256). The horizontal and vertical motion units use
N, where N = (n + n
L H
the horizontal and vertical values set by the GS P command.
Rev B 4/13/99
Epson Commands
Command Descriptions
n n
L H
n n
L H
n n
L H
× 256) × (vertical or horizontal
+ n
L H
n n
L H
n n
L H
n n
L H
[E]
[E]
×
+ n
L H
Page 87