Connecting The Cash Drawer - Ithaca PcOS Series 80PLUS Programmer's Manual

Setting up the Printer

Connecting the Cash Drawer

The cash drawer option allows up to two cash drawers to be connected to the printer in a system with
a PC that has no connectors for the cash drawer cables.
The cash drawers are operated by software command from the host system through the printer. For
additional information on the printer commands used by the host system to activate the cash drawers,
see "Control Code Library" later in this manual.
1. Plug the cash drawer cables into the connectors on the printer. The connectors are standard
phone connectors.
2. If only one cash drawer is used, plug the cable into the connector labeled 1.
NOTE: The following illustration shows the pin outs for the cash drawer connectors, as viewed from
the rear of the unit. Drawer #2 can be configured to be the same as #1 via jumper J-7.
Drawer 2
1 2 3 4 5 6
Figure 2 Pin outs for cash drawer connectors
Page 6
PcOS Series 80PLUS
Drawer 1 Power Connector
1 2 3 4 5 6
Rev B 4/13/99
Programmer's Guide