Ithaca PcOS Series 80PLUS Programmer's Manual page 31

Programmer's Guide
Function
ASCII
Hexadecimal
Decimal
IPCL
Description
Function
ASCII
Hexadecimal
Decimal
IPCL
Description
Function
ASCII
Hexadecimal
Decimal
IPCL
Description
Function
ASCII
Hexadecimal
Decimal
IPCL
Description
Function
ASCII
Hexadecimal
Decimal
IPCL
Description
PcOS Series 80PLUS
Set variable line space n/72 inch
[ESC] A <n>
1BH 41H <n>
<27><65><n>
none
This command sets default line spacing to n/72 inch. Set n = 1 to 85. This line
spacing does not take effect until enabled by the [ESC] 2 command. This
command is provided to maintain backward compatibility with Series 50,
OKIDATA, IBM, and other printers. It can also be used to print on preprinted
forms.
Enable [ESC] A <n> line spacing
[ESC] 2
1BH 32H
<27><50>
none
[ESC] 2 enables [ESC] A <n> line spacing. This is a companion to the [ESC]
A <n> command and puts the specified line spacing into effect. It will remain
in effect until another line spacing command is issued.
Feed <n> lines at current spacing
[ESC] d <n>
1BH 64H <n>
<27><100> <n>
&%FL <m > <m >
1 2
This command prints the contents of the buffer (if any) and performs <n> line
feeds at the current line spacing. This command does not change the default
line spacing value. The next character print position is reset to the left margin.
NOTE: The IPCL command will print from 00 to 99 lines. For example, if you
wish to feed 12 lines, the IPCL command would be &%FL12.
Form feed
[FF]
0CH
<12>
&%FF
This command performs a form feed to cut.
Begin auto line feed
[ESC] 5 <01>
1BH 35H 01h
<27><53><01>
&%MA
This command sets auto line feed mode.
NOTE: This overrides the configuration setting.
Rev B 4/13/99
Control Codes
Vertical Motion
Page 21