Vertical Motion Control - Ithaca PcOS Series 80PLUS Programmer's Manual

Control Codes
Vertical Motion

Vertical Motion Control

Function
ASCII
Hexadecimal
Decimal
IPCL
Description
Function
ASCII
Hexadecimal
Decimal
IPCL
Description
Function
ASCII
Hexadecimal
Decimal
IPCL
Description
Function
ASCII
Hexadecimal
Decimal
IPCL
Description
Page 20
PcOS Series 80PLUS
Fine line feed
[ESC] J <n>
1BH 4AH <n>
<27> <74><n>
&%FM <m > <m > <m >
1 2 3
This command prints the contents of the buffer (if any) and performs a line feed
of n/216 inch. This command does not change the default line spacing value.
The next character print position is reset to the left margin if the Auto-CR
mode is set.
EPOS NOTE: In EPOS mode, this command performs line feeds in n/144-
inch increments.
Set variable line space to n/216 inch
[ESC] 3 <n>
1BH 33H <n>
<27><51><n>
&%SV <m > <m ><m >
1 2 3
This command sets the default line spacing to n/216 inch. Set n = 1 to 255.
This command sets the line feed spacing used by [LF] to values other than 1/8
or 7/72 inch. This command takes effect immediately as opposed to the [ESC]
A <n> command.
EPOS NOTE: Line spacing of n/144 is used.
Set line space 27/216 inch
[ESC] 0
1BH 30H
<27><48>
&%ST
This command sets the default line spacing to 1/8 inch (27/216 inch). This is a
standard 8 lines per inch line spacing. This is the default text line spacing at
initial power-up.
EPOS NOTE: In EPOS mode, this command sets 1/6-inch spacing or 6 lines
per inch.
Set line space 21/216 inch or (7/72 inch)
[ESC] 1
1BH 31H
<27><49>
&%SG
This command sets the default line spacing to 21/216 inch. This line spacing is
for all-points-addressable (APA) graphics printing.
Rev B 4/13/99
Programmer's Guide