Ithaca PcOS Series 80PLUS Programmer's Manual page 81

Programmer's Guide
Function
ASCII
Hexadecimal
Decimal
Description
Hex Decimal
00 0
01 1
02 2
03 3
Function
ASCII
Hexadecimal
Decimal
Range
Description
Function
ASCII
Hexadecimal
Decimal
Range
Description
PcOS Series 80PLUS
Print single user-definable bit-image
GS /
1DH 2FH
<29> <47>
This command prints a downloaded or stored bit-image using the mode
specified by m. m selects a mode from the table below:
Mode Table
Mode Vertical Dot Density
Normal
Double-width
Double-height
Quadruple
Save user definable character set
GS 6
1DH 36H
<29> <54>
<name> = a 15-byte maximum alphanumeric name to identify the image.
GS 6 saves the current character set created by the "ESC &" command to
the nonvolatile memory pool. If no character set has been defined, this
command will be ignored. When saving an image, the printer will go off-
line and will return on-line when completed. Please be sure to adhere to
flow-control provided by the communication interface.
Once a character set has been saved to the nonvolatile memory pool it is
"read-only". Any attempt to redefine a character when this set is selected
will cause a new character set to be defined in RAM according to the "ESC
&" command.
Select user definable character set
GS 7
1DH 37H
<29> <55>
<name> = a 15-byte maximum alphanumeric name to identify the image.
GS 7 selects a previously saved user defined character set with the name
<name>. If the character set does not exist, this command will be ignored.
Any characters referenced that are not defined in the set will be replaced as
follows: equivalent Code Page 437 character in Axiohm 7193 emulation
and equivalent current code page character in Epson TM-T8x emulation.
Rev B 4/13/99
Epson Commands
Command Descriptions
m
m
m
Horizontal Dot Density
(dpi)
203
203
101
101
<name> 0
<name> 0
<name> 0
<name> 0
<name> 0
<name> 0
[EAI]
(dpi)
203
101
203
101
Page 71