Ithaca PcOS Series 80PLUS Programmer's Manual page 84

Epson Commands
Command Descriptions
Function
ASCII
Hexadecimal
Decimal
Range
[Axiohm 7193]
[Epson TM-T8x]
Description
Function
ASCII
Hexadecimal
Decimal
Range
[Axiohm 7193]
[Epson TM-T8x]
Description
Page 74
PcOS Series 80PLUS
Define user-defined characters
ESC & y c1
1BH 26H y c1
<27> <38> y c1
y = 3
0 ≤ x ≤ 13 Font A (13 × 24)
0 ≤ x ≤ 10 Font B (10 × 24)
0 ≤ d1 ... d(y × xk) ≤ 255
k = c2 - c1 + 1
32 ≤ c1 ≤ c2 ≤ 254
32 ≤ c1 ≤ c2 ≤ 126
This command defines user-defined characters.
y specifies the number of bytes in the vertical direction.
c1 specifies the beginning character code for the definition.
c2 specifies the final code.
x specifies the number of dots in the horizontal direction.
d is the dot data for the characters. The dot pattern is in the horizontal
direction from the left side. Any remaining dots on the right side are
blank.
The allowable character code range differs between Epson and Axiohm
emulation. See Range above.
The data to define a user-defined character is (y × x) bytes.
Set a corresponding bit to 1 to print a dot or 0 to not print a dot.
In Epson emulation mode, there is a unique user defined character set for
each pitch. In Axiohm emulation mode, both pitches share the same user
defined character set.
Cancel user-defined characters
ESC ?
1BH 3FH
<27> <63>
32 ≤ n ≤ 254
32 ≤ n ≤ 126
This command cancels user-defined characters.
Rev B 4/13/99
Programmer's Guide
c2 [x1 d1...d(y × x1)]...[xk d1...d(y × xk)]
c2 [x1 d1...d(y × x1)]...[xk d1...d(y × xk)]
c2 [x1 d1...d(y × x1)]...[xk d1...d(y × xk)]
n
n
n
[EA]
[E]