Programmer's Guide
Character Attribute Commands
Function
ASCII
Hexadecimal
Decimal
IPCL
EPOS
Description
Figure 10 Example of one-line double-wide
print
Function
ASCII
Hexadecimal
Decimal
IPCL
EPOS
Description
12/14/99
PcOS Series 150
Begin one-line double-wide print
[SO]
0EH
<14>
&%MW
none
This command causes subsequent characters to be printed at twice the currently
selected character width. For example ten cpi becomes five cpi, 17 cpi becomes
8.5 cpi, and so on. This command will remain in effect until:
a. a valid line terminator is received (CR, LF, or fine line feed);
b. the command is canceled; or
c. the maximum number of characters per line is reached and the printer
performs an auto print.
Cancel one-line double-wide print
[DC4]
14H
<20>
&%MN
none
This command cancels one-line double-wide mode set by the [SO] command
and allows single- and double-wide characters to be printed on the same line.
Rev G
Example of one line Double Wide[CR][LF]
This is normal 12 cpi Print[CR][LF]
[SO]
Double Wide[CR][LF]
This is back to normal[CR][LF]
Figure 11 Data sent to printer for one-line
double-wide print
Control Codes
Character Attributes
Page 33