Ithaca PcOS Series 80PLUS Programmer's Manual page 111

Programmer's Guide
Function
ASCII
Hexadecimal
Decimal
Range
Description
Bit Off/On
0 Off
On
1-4 -
5 On
6 On
7 -
Function
ASCII
Hexadecimal
Decimal
Description
PcOS Series 80PLUS
Execute macro
GS ^
1DH 5EH
<29> <94>
0 ≤ r ≤ 255
0 ≤ t ≤ 255
m = See below
This command executes a macro definition.
r specifies the number of times to execute the macro. When Bit 1 of m is
set, r is ignored, and the macro is executed infinitely.
t specifies the waiting time for executing the macro; it is t × 100 msec for
every macro execution.
m specifies macro executing mode.
When the LSB of m = 0, the macro executes r times continuously with
interval specified by t.
When the LSB of m = 1, after waiting for the period specified by t, the
printer remains idle and waits for the FEED button to be pressed. After the
button is pressed, the printer executes the macro once. The printer repeats
this operation r times.
When Bit 5 of m is set, the current macro definition is saved into the
printer's nonvolatile EEPROM memory as a start-up macro without
executing it. This macro definition will be executed upon power-up using
the parameters specified by this command. If the printer is powered-up into
self-test mode, the macro definition will not be executed. A saved macro
definition can be deleted with the GS _ command.
Hex Decimal Function
00 0 Macro executes r times continuously with the interval
specified by t.
01 1
FEED button controlled operation with time interval t
- - Undefined
20 32
Value given by r is ignored and macro is run infinitely.
40 64 Save start-up macro definition to EEPROM memory
without executing
- - Undefined
Delete start-up macro definition
GS _
1DH 5FH
<29> <95>
This command deletes a start-up macro definition previously created by the
GS ^ command. If a start-up macro was not previously defined, this
command is ignored.
Rev B 4/13/99
Epson Commands
Command Descriptions
r t
r t
r t
[EI]
m
m
m
[I]
Page 101