Vertical Motion Control; Figure 7 Example Of Fine Line Feed; Figure 8 Data Sent To Printer For Fine Line Feed - Ithaca 150 Programmer's Manual

Control Codes
Vertical Motion

Vertical Motion Control

Function
ASCII
Hexadecimal
Decimal
IPCL
EPOS
Description

Figure 7 Example of fine line feed

Function
ASCII
Hexadecimal
Decimal
IPCL
EPOS
Description
Function
ASCII
Hexadecimal
Decimal
IPCL
EPOS
Description
Page 18
PcOS Series 150
Fine line feed
[ESC] J <n>
1BH 4AH <n>
<27> <74> <n>
&%FM <m > <m > <m >
1 2 3
[ESC] J <n>
This command prints the contents of the buffer (if any) and performs a line feed
of n/216 inch. This command does not change the default line spacing value.
The next character print position is reset to the left margin.
EPOS Note: In EPOS mode, this command performs line feeds in n/144-inch
increments.
Example of Fine Line Feed[CR]
[ESC]J<54>
This line is 1/4" below the first.[CR][LF]
This
1/8".[CR][LF]

Figure 8 Data sent to printer for fine line feed

Set variable line space in n/216 inch
[ESC] 3 <n>
1BH 33H <n>
<27> <51> <n>
&%SV <m > <m > <m >
1 2 3
[ESC] 3 <n>
This command sets the default line spacing in n/216 inch. Set n = 1 to 255.
This command takes effect immediately and sets the line feed spacing used by
[LF] to values other than 1/8 or 7/72 inch.
EPOS Note: Line spacing of n/144 is used.
Set line space to 27/216 inch
[ESC] 0
1BH 30H
<27> <48>
&%ST
[ESC] 2
This command sets the text default line spacing to 1/8 or 27/216 inch which is
the standard eight lines per inch line spacing at initial power up.
EPOS Note: In EPOS mode, this command sets 1/6-inch spacing or 6 lines per
inch.
Rev G
Programmer's Guide
line is spaced at the default of
12/14/99