Chassis Package Contents; Leaf Package Contents - Mellanox Technologies MSX6512-NR Hardware Installation Manual

Rev 1.0
The system requires a KVA rated UPS system. It is recommended that a UPS system
be installed to protect the equipment in the event of unexpected power failure.
Make sure that the outlets and circuits will not be overloaded. Spread out the load over
at least two or three circuits or use a 3 phase circuit. N+N grid redundancy requires 2
independent power supply sources.
1.2

Chassis Package Contents

The chassis package includes:
• 1 chassis with the following modules installed:

4 fans

4 PSUs
If you are not using a mechanical lift to install the chassis,reduce the weight of the chassis by
removing all of the power supply units, and fan units, and put aside for reinstallation after the chas-
sis is installed in the rack.
• 1 installation kit
• 1 box containing 4 power cords 250v 15a 2.0M, C14 to C13, USA UL Standard
• 1 cable management kit
• 1 Installation Guide
Before you install your new SX6512 chassis, unpack the system and check to make sure that all
the parts have been sent, check this against the parts list see "Installation and Cable Management
Kit Parts" on page 12. Check the container for visible damages that may have occurred during
shipping.
If anything is damaged or missing, contact your customer representative immediately.
The rack mounting holes conform to the EIA-310 standard for 19-inch racks. Guaran-
tee proper ventilation, by leaving 8cm (3") of space to the front and rear of the switch.
This will ensure proper air flow through the chassis. This is crucial for maintaining
good airflow at ambient temperature. In particular, route cables such that they do not
impede the air into or out of the chassis.
1.3

Leaf Package Contents

The leafs are ordered by the customer and are shipped 4 to a box. The customer will receive as
many boxes as needed to fill the order.
10
Chassis Installation
Mellanox Technologies