Table of Contents
Advertisement
InfiniBand Switch Platform Hardware User Manual
2. Set the bottom of the cable holder at the level of the shelf.
Notch for upper
bracket washer
Set this even with
the top of the shelf
3. Screw the cable holder onto the rack using the screws provided.
4. Repeat steps 1- 3 for the second cable holder.
5. Install the shelves. The cable support shelves just sit on the cable holders.
6. Use the holes in the shelves to tie down the cables individually or in bundles.
Mellanox Technologies
If the cable holder is not set properly the upper bracket will not line up with the cable
holder.
Figure 10: Cable Holder Placement
L
Use Velcro ties to tie down the cables. Electric cable ties are not recommended.
26
Advertisement
Table of Contents
