Table of Contents
Advertisement
InfiniBand Switch Platform Hardware User Manual
8. Screw the 8 screws through the faceplate and into the caged nuts.
9. Slide the rail slides to the vertical rails.
Holes in the faceplate for mounting on the rack.
10. Place the 4 holed spacer on the outside of the vertical support and screw in the 4
screws for each rail slide. Use the split lock washers here.
11. Remove the two handles from the spine side and save all four handles for future use.
12. Ground the switch.
13. Install all of the spines, leafs and management modules.
14. Install any power supply units, and fan units removed at the start of the installation
procedure.
15. Insert all leafs that you plan to use, in the chassis. Start at the bottom of the chassis
and work your way up.
16. Insert the first two spines in the top two slots.
17. Insert the rest of the spines from the bottom of the chassis up to slot #3.
18. Insert thermal blanks in unused leaf slots to maintain balanced air flow.
19. Tighten all leaf and spine mounting screws.
Mellanox Technologies
Figure 17: IS5200 Chassis on the Shelf
Figure 18: Face Plate Mounting Bolt Locations
Mellanox
®
Fan #1
Fan #2
L
S1
FAN
PS1
S2
FAN
S3
FAN
S4
FAN
PS3
FAN
S5
S6
FAN
Fan #3
Fan #4
IS5200
R
PS2
PS4
31
Advertisement
Table of Contents
