Table of Contents
Advertisement
Unpacking the Disk Drive
!
Before You Start
This chapter:
•
Gives information about unpacking a new disk drive
•
Lists the tools and equipment required to install a 2.1 Gbyte standard
connector hard disk drive in a Desktop Disk Pack and a Multi-Disk Pack
•
Provides software commands to shut down your operating system
•
Describes the drive jumper settings
•
Points you to the proper chapter for information specific to your system
Caution – Make sure you handle the drive carefully. Any jarring movement or
hard impact could damage the drive.
When you unpack the disk drive from the shipping box:
1. Compare the packing list with the hardware you received.
2. Place the drive on an antistatic surface, (such as the antistatic bag in
which the drive was shipped), with the printed circuit board (PCB) side
up.
3. Save the box and the packing material in case you have to ship the drive
at some future date.
1
1-1
Advertisement
Table of Contents
