Multi-Disk Pack - Sun Microsystems 2.1 Gbyte 7200 rpm Installation Manual

Multi-Disk Pack

This chapter explains how to remove a disk drive and how to install a
2.1 Gbyte hard disk drive in the Multi-Disk Pack unit. Tasks which are
common to all systems are described in the Preface and Chapter 1.
Read the Safety Precautions and Safety Agency Compliance
Verify the version of your software environment
Shut down your system
Remove the cover
Remove the disk drive assembly
Remove the disk drive(s) from the assembly
Set disk drive SCSI address
Install the new disk drive in the disk drive assembly
Replace the disk drive assembly
Replace the cover
Turn on power to your system
Configure your system
3
page -x
page 1-3
page 1-3
page 3-2
page 3-5
page 3-7
page 3-8
page 3-12
page 3-13
page 3-3
page 3-16
page 3-16
3-1