Table of Contents
Advertisement
B
Terminating SCSI Devices
B-6
Table B-2 Devices Supported With Additional Single-ended SCSI Buses (SunOS 4.1.x)
SCSI Bus Number
SCSI bus 1, first FSBE/S SBus card
SCSI bus 2, second FSBE/S SBus card
SCSI bus 3, third FSBE/S SBus card
SCSI bus 4, fourth FSBE/S SBus card
Note – For the Solaris 2.x operating system, tape, disk and CD-ROM devices
are supported on all SCSI buses
You must attach a regulated SCSI terminator to the SCSI port at the end of the
SCSI bus. A terminator holds the bus at a predetermined signal level when the
bus is not active and maintains impedance matching.
All SCSI daisy chains must be terminated at the last unit attached to the SCSI
bus. Also, a terminator is built in to all SBus SCSI cards and to all host systems
to terminate that end of the bus. The regulated terminators must be used for all
50-pin SCSI buses having fast SCSI drives on a fast SCSI host.
2 Gbyte Standard Connector Disk Drive Installation Manual—May 1995
Device
Disk
Tape
CD-ROM
Disk
Disk
Tape
CD-ROM
Disk
Advertisement
Table of Contents
Need help?
Do you have a question about the 2.1 Gbyte 7200 rpm and is the answer not in the manual?