Table of Contents
Advertisement
Desktop Disk Pack
The tasks required to remove and replace a disk drive in the Desktop Disk
Pack (DDP) are listed below. Tasks which are common to all systems are
described in the Preface and Chapter 1.
Read the Safety Precautions and Safety Agency Compliance
Verify the version of your software environment
Shut down your system
Remove the cover
Remove the disk drive (if necessary)
Set the SCSI target address
Install the new disk drive
Replace the cover
Turn on power to your system
Configure your system
2
page -x
page 1-3
page 1-3
page 2-3
page 2-6
page 2-10
page 2-10
page 2-4
page 2-15
page 2-15
2-1
Advertisement
Table of Contents
Need help?
Do you have a question about the 2.1 Gbyte 7200 rpm and is the answer not in the manual?
Questions and answers