Table of Contents
Advertisement
2
Replacing the DDP Cover
2-4
Figure 2-3
Attaching the Wrist Strap
1. Make sure there are no loose tools or screws in the unit, and that all
internal components are seated properly.
2. Make sure that all internal cable connections are secure, and that the
power supply cord is tucked inside the system to avoid pinching the
wiring when you replace the cover.
3. Remove the wrist strap.
4. Holding the cover at an angle, engage the front tabs of the cover with the
front of the unit.
See Figure 2-4.
2 Gbyte Standard Connector Disk Drive Installation Manual—May 1995
Advertisement
Table of Contents
Need help?
Do you have a question about the 2.1 Gbyte 7200 rpm and is the answer not in the manual?
Questions and answers