Sun Microsystems 2.1 Gbyte 7200 rpm Installation Manual page 17

3. Type /usr/sbin/shutdown -y -g30 -i0 and press Return.
tutorial# /usr/sbin/shutdown -y -g30 -i0
.
.
.
.
ok
Note – The 0 in g30 and i0 is a zero.
A message is sent notifying all users who are logged in that they have 30
seconds (-g30) before the system begins to shut down. The ok or > prompt
is displayed after the operating environment is shut down.
4. At the > or ok prompt, turn the on/off switch to the off (O) position for
each device in the following order:
a. Peripherals
b. Desktop system
c. Monitor
Warning – Be sure all power switches are turned to the off (O) position. The
green light emitting diodes (LEDs) on all units should not be lit and the power
supply fans should not be running. Leave all power cords plugged into each
unit and wall outlet(s) to prevent damage to the equipment.
Caution – After turning off the power, always wait 10 seconds before turning it
!
on again. This pause prevents possible damage to power supply components
in the desktop system.
Before You Start
1
1-5