How To Create A Route; How To Create A New Route - Furuno MFD12 Operator's Manual

5. Routes
5.2

How to Create a Route

5.2.1

How to Create a New Route

The route points of an inactive route are marked on the display with a blue square and
a blue line runs between points.
1. Put the cursor on the 1st point for the route.
2. Push the right-click button to show the Cursor Position pop-up menu.
3. Use the RotoKey to select [New Route].
4. Use the CursorPad to move the cursor to the next point in the route. When you
move the cursor, a blue dashed line runs between the previous point and the cur-
sor location. See the figure shown below.
5. Press the left-click button to save the point. The line between the first point and
second point changes from dashed to solid.
6. Move the cursor to the next point in the route then press the left-click button.
Repeat this step to enter all route points.
7. At the last route point, push the RotoKey to complete the route and save the route
to the Routes list.
The route is saved to the Routes list under the youngest empty route number with
"RTE" before the route number. A solid blue line runs between route points (blue
squares).
5-2
Go To
Go To by Position
New Point
New Route
Center on Boat
1st point
(starting point)
Route leg (blue)
Route point (blue)
Cursor
+
2nd point