Parameters - Furuno FEA-2107-BB Installation Manual

3.2

Parameters

NOTE: Special attention to following topics is required to maintain "Consistent Common
Reference System."
• The values of center and conning positions depend on size and geometry of the ship.
• Offsets from Antenna Position to Conning Position of Position Sensors depend on the
location of position sensor antennas.
• Offsets from Antenna Position to Conning Position of Radars depend on the location of
radar antennas.
Installation parameters have limited access, and are controlled by an Authorizing key disk
(supplied). The Authorizing key disk is a floppy which contains the necessary key to allow
access into editing of the installation parameters. Do the following to access the installation
parameters.
1. Insert the "Authorization key disk" to the processor unit.
Note that the installation parameters have limited access, which is controlled by the
Authorization key disk supplied.
2. Press the MENU key on the control unit to open the menu.
3. Roll the wheel to choose Initial Settings, and then push the wheel.
4. Locate the cursor on the ► next to INITIAL SETTINGS to show Initial settings menu.
5. Roll the wheel to choose Installation parameters and push the wheel.
(Program version 05.xx)
There are several buttons in this dialog box, and they are described below:
Set parameters defaults: This restores Installation parameters which are saved as a
backup copy by service personnel. Use this function if you are not sure about Installation
parameters values.
Sensor channel usage: The CH and sensors are shown.
Set Single Workstation Mode: This button is used to set Workstation to operate as a
single workstation.
Workstations
This button is used to define names, source of sensors and location of Access Server of
Workstations if two workstations are installed.
(Program version 06.xx)
3. ADJUSTMENTS
3-3