F2) Afm Operator Eg (All Operators); Fl) Operator Output (Each) - Yamaha SY77 Operating Manual

AFM ELEMENT DATA

3. (F2) AFM operator EG (All operators)

Summary: Make operator EG settings for all oper-
ators while viewing the data for all operator EGs
in a single screen.
Procedure:
From: AFM Element job directory (JUMP #230)
Select: job 03:EG and press F2 (All)
Specify: EG key-on rates (R1-R4)
EG key-on levels (L1-L4)
EG key-off rates and
levels (RR1-2, RL1-2)
AFM ELEMENT DATA
Summary: Set output level and scaling for a single
operator while viewing a graphic display of the
scaling.
Procedure:
From: AFM Element job directory (JUMP #230)
Select: job 04:0utput and press
F1 (Each)
Specify: the output level and scaling for the
selected operator
(JUMP #238)
(JUMP #239)
(JUMP #240)
4. (F1) Operator output (Each)
(JUMP #241)
HT (Keyon Delay Time 63...0): This specifies
the time by which the beginning of the EG will
be delayed after a key is pressed.
R1-R4 (Keyon Rates 0...63): Keyon Rates 1-4
determine the speed of the operator EG while a
key is being pressed.
RS (Rate Scaling -7...+7): Rate Scaling deter-
mines how the key position will affect the oper-
ator EG rates.
L0-L4 (Keyon Levels 0...63): These determine
the levels to which the operator EG will move
while a key is being pressed.
LP (Segment Loop Point S1...S4): This specifies
the segment from which the EG will continue
looping if a key remains depressed after the EG
has arrived at level L4.
R1, R2 (KeyOff Rates 0...63): These determine
the speed with which the operator EG will
change levels after a key is released.
L1, L2 (KeyOff Levels 0...63): These determine
the levels to which the operator EG will change
after a key is released.
The meaning of these EG parameters is explained in
the previous section 3.1 Operator EG.
In this AFM operator EG (All) display, the
OPERATOR SELECT buttons cannot be used to select
operators.
Output Level (0...127): The output level of the
operator
BP1-4 (Breakpoint 1-4): Note (C-2...G-8) and
Offset (-127...#127) of each Break Point deter-
mine how the output level of each operator will
VOICE EDIT MODE
JUMP #238
JUMP #241
125