F2) Modulation Effect 1 Set (Parameters); Fl) Reverb Effect 1 Set (Data) - Yamaha SY77 Operating Manual

COMMON DATA / EFFECT SET

10.2 (F2) Modulation effect 1 set (Parameters)

Summary: Set effect parameters of the effect type
selected for modulation effect 1. This explanation
also applies to modulation effect 2.
Procedure;
From: Effect Set job directory
Select: 02:Modulation Effect 1 Set
Press: F2 (Parm)
Specify: parameter settings for the selected effect
The number and type of effect parameters will
depend on the selected Effect Type. Refer to the
following parameter lists for each effect type.
Through has no parameters.
To select an Effect Type and set Effect Balance
and Output level, press F1 (Data). (See the
previous section 10.2 (F1).)
Note: Changing the Effect type in F 1 (Data) will
initialize these Parameter settings.
Through: The input sound will be output without any
processing.
1:St.Chorus (stereo chorus)
Modulation Frequency (0.2...20.0 Hz)
Pitch Mod. Depth (0...100%)
Amplitude Modulation Depth (0...100%)
COMMON DATA / EFFECT SET
Summary: Select an effect type for Reverb effect 1,
and set the effect balance and output level. This
explanation also applies to reverb effect 2.
Procedure:
From: Effect Set job directory
Select: 04:Reverb Effect 1 Set
Press: Fl (Data)
Specify: the effect type, effect balance, and output
level
(JUMP #211)
(JUMP #214)
10.4 (F1) Reverb effect 1 set (Data)
(JUMP #211)
(JUMP #217)
2:St.Flange (stereo flanger)
Modulation Frequency (0.2...20 Hz)
Modulation Depth (0...100%)
Modulation Delay Time (0.2...15
Feed Back Gain (0...99%)
3:Symphonic
Modulation Frequency (0.2...20 Hz)
Modulation Depth (0...100%)
4:Tremolo
Modulation Frequency (0.2...20 Hz)
Modulation Depth (0...100%)
Phase (-8...+8)
Modulation effect parameters: The parameters of
the modulation effects are explained below in
alphabetical order.
Amplitude Modulation Depth: The amount of
tremolo; i.e., cyclical change in volume.
Feedback Gain: For effects with very short
delays such as 2.St.Flange, this will adjust
the character of the effect.
Modulation Depth: The depth of the cyclical
change.
Modulation Delay Time: For effects with very
short delays such as 2.St.Flange, this will
adjust the character of the effect.
Modulation Frequency: The speed of the cyclical
change; i.e., the speed of chorusing, flanging,
etc.
Pitch Modulation Depth: The amount of vibrato;
i.e., cyclical change in pitch.
Phase: The phase of the pitch shifted signal.
VOICE EDIT MODE
JUMP #214
ms)
JUMP #217
103