Afm Filter; Copy Filter; Cutoff Frequency - Yamaha SY77 Operating Manual

AFM ELEMENT DATA
Summary: The two filters of each element can be
used to control the tone in various ways.
Procedure:
From: AFM Element job directory (JUMP #230)
Select: job 08:Filter
Specify: the desired job and press ENTER
AFM ELEMENT DATA / AFM FILTER
Summary: Any time while editing a filter, you can
copy the data from one filter to the other filter.
Procedure:
From: 8.1 Cutoff Frequency
8.2 Cutoff Scaling
8.3.CutoffEG
Press: COPY
Select: the copy direction (1 2 or 2
To execute: the copy operation press P8 (Go)
To quit: without copying press EXIT
AFM ELEMENT DATA / AFM FILTER
Summary: Each filter can be set to a different type,
cutoff frequency, and control source. Overall
resonance, velocity sensitivity, and LFO Cutoff
Sensitivity can also be specified.
Procedure:
From: AFM Element job
directory 8. AFM filter
Select: 01:Cutoff Frequency
Specify: parameters for filters 1 and 2

8. AFM filter

(JUMP #248)

8.0 Copy filter

(JUMP #249)
(JUMP #250)
(JUMP #252-#255)
1)

8.1 Cutoff frequency

(JUMP #248)
(JUMP #249)
Move the cursor in this area to select a job and
press ENTER to move to the selected job.
01: Cutoff Frequency: Make overall settings for
the filters.
02: Cutoff Scaling: Specify how each filter will be
adjusted across the keyboard.
03: Cutoff EG: Specify how each filter will
change over time.
Pressing F1-F3 will select the corresponding job.
Specify whether to copy the data from filter 1 to filter
2 (1->2) or from filter 2 to filter 1 (2->1). Press F8
(Go) and the data will be copied. If you decide not to
copy the data, press EXIT to exit without copying.
The filter type (HPF/LPF/THRU) will not be
copied.
Filter 1 Type (Thru, LPF, HPF): Filter 1 can be
used either as a Low Pass Filter (LPF) or as a
High Pass Filter (HPF). When "Thru" is
selected the filter will have no effect.
VOICE EDIT MODE
JUMP #249
131