Afm Sensitivity; Fl) Afm Lfo (Main) - Yamaha SY77 Operating Manual

AFM ELEMENT DATA
Summary: These settings determine how each
operator will be affected by key-on velocity and
by the LFO.
Procedure:
From: AFM Element job directory (JUMP #230)
Select: job 05:Sensitv
Specify: the sensitivity of each operator
Velocity (-7...+7): This determines how the
output level of each operator will be affected by
key-on velocity. For positive settings (+1...+7)
the output level will increase as you play more
strongly. For negative settings (-1...-7) the
output level will decrease as you play more
strongly.
Rate Velocity (on/off): When the Rate Velocity
switch is "on", key-on velocity will affect the
operator EG R1. The result will depend on the
Velocity setting.
Velocity = +1...+7: If Rate Velocity is on,
strongly played notes will cause the operator
EG R1 to increase, resulting in a faster attack.
For notes played with maximum velocity, R1 will
be at the value specified by the EG settings.
Velocity = -1...-7: If Rate Velocity is on,
strongly played notes will cause the operator
EG R1 to decrease, resulting in a slower attack.
To hear the effect of negative settings you will
need to lower the operator output level.
When the Rate Velocity switch is "off, the
operator EG R1 will not be affected by key-on
velocity.
AFM ELEMENT DATA
Summary: The Main LFO creates a cyclically
changing control signal that can be used to
create tremolo (amplitude modulation), vibrato
(pitch modulation),
modulation).

5. AFM sensitivity

(JUMP #243)
6. (F1) AFM LFO (Main)
and wah-wah (filter
AModSens (0...7): Amplitude Modulation
Sensitivity determines how greatly the output
level of each operator will be affected by Ampli-
tude Modulation from the LFO.
PModSens (0...7): Pitch Modulation Sensitivity
determines how greatly the pitch of each oper-
ator will be affected by Pitch Modulation from
the LFO.
Pressing F1 (KVS), F2 (Rate), F3 (AMS), or F4
(PMS) will move the cursor to Velocity, Rate
Vel, AModSens, or PModSens.
AModSens and PModSens: These settings deter-
mine the sensitivity of each operator to the Ampli-
tude Modulation Depth (AMD) and/or Pitch Modu-
lation Depth (PMD) produced by the LFO. Refer to
6.(F1) AFM LFO (Main) (JUMP #244). If the LFO
settings for AMD and/or PMD are set to 0, these
AModSens and PModSens settings will have no
effect.
PModSens determines the sensitivity of each
operator to PMD
Independently of this, the pitch of an AFM element
can also be affected by the Sub LFO. Refer to
6. (F2) AFM LFO (Sub) (JUMP #245).
In this AFM sensitivity display, the OPERATOR
SELECT buttons cannot be used to select operators.
Procedure:
From: AFM Element job directory (JUMP #230)
Select: job 06:LFO and press
F1 (Main)
Specify: parameters for the main LFO
VOICE EDIT MODE
JUMP #243
from the Main LFO.
JUMP #244
(JUMP #244)
127