Yamaha SY77 Operating Manual page 237

Summary: Card utility jobs allow you to transfer
data to and from a card, and to format a card to
accept SY77 data.
Procedure:
From: System Utility, MIDI Utility, or Disk
Utility
Press: F3 (Card)
Select: the desired card utility job and press
ENTER.
CARD UTILITY
Summary: Synthesizer data can be saved to a RAM
card.
Procedure:
From: card utility job directory (JUMP #812)
Select: 01:Save To Card
To execute: the operation press F8 (Go).
To quit: without executing press EXIT.
This job saves all synthesizer data to a RAM card
inserted in the DATA card slot. Before a newly pur-
chased RAM card can be used by the SY77 it must
be formatted using the 3. Format card function
explained later in this section.
Card utility
(JUMP #800, #806, #816)
(JUMP #812)
1. Save to card
(JUMP #813)
Move the cursor in this area to select one of the
following jobs and then press ENTER.
01: Save To Card: Synthesizer data can be
saved to a RAM card.
02: Load From Card: Synthesizer data can be
loaded from a RAM or ROM card.
03: Card Format: Before you use a new RAM
card, you must use this operation to format it
so that the card can be used by the SY77.
Press F8 (Go) to save the synthesizer data to
card. The display will ask "Are you sure?" so if you
are sure you want to save the data press YES.
If the card inserted in the DATA card slot has not
been formatted for the SY77 the LCD will show
"Warning: Format Error !" Press EXIT to exit from
the error message.
This function saves the following data to RAM card.
Setup data (system data, pan data, micro tuning
data)
Internal voices 1-64
Internal multis 1-16
UTILITY MODE
JUMP #812
JUMP #813
225