Send Tmo; Set Probe Interval; Unbind - 3Com EtherLink 3C985B-SX User Manual

send tmo

This command sets the timeout value, in seconds, that
Load Balancing/RSL software waits before retransmitting a
probe packet when a send request to the link support layer
(LSL) is not acknowledged.
Syntax
Example
Default
Messages

set probe interval

This command sets the probe packet interval.
Syntax
Example
Default
Messages

unbind

This command deletes a Load Balancing/RSL group (the
LAN driver for the group cannot be loaded).
Syntax
Example
Default
Messages
Load Balancing/RSL Commands
el980lb send tmo pri_slot value_in_seconds
where:
pri_slot is the PCI slot number of the primary NIC.
value_in_seconds is any positive integer.
el980lb send tmo 1001 20
10
A separate message is displayed for each loaded
frame type.
el980lb set probe interval in_ticks
where in_ticks is the time in ticks (18 ticks = 1 second).
el980lb set probe interval 60
18
If the delay is longer than 1 second, NIC or link failures
are not recognized as quickly.
If no argument is specified or the specified argument is
invalid, the current value is displayed. Otherwise, the
new value is displayed.
el980lb unbind pri_slot
where:
pri_slot is the PCI slot number of the primary NIC.
el980lb unbind 10001
None
If successful, Load Balancing/RSL software displays this
message for all frame types that the NIC supports:
Cleaning up resources for group
associated with Primary Slot # xxxx.
55