Receive Tmo; Retry Count - 3Com EtherLink 3C985B-SX User Manual

54 C
HAPTER

receive tmo

This command sets the receive timeout individually for each
Load Balancing/RSL group.
Syntax
Example
Default
Messages

retry count

This command sets the number of retries that
Load Balancing/RSL software attempts when a probe
packet fails to appear at the receive end, before the
software puts a board in Wait mode.
Syntax
Example
Default
Messages
4: I C
NSTALLING AND
el980lb receive tmo pri_slot in_ticks
where:
pri_slot is the PCI slot number of the primary NIC.
in_ticks is the time in ticks (18 ticks = 1 second).
el980lb receive tmo 10001 1
18 ticks
This default may have to be set higher for some
network configurations.
A separate message is displayed for each loaded
frame type.
el980lb retry count number_of_retries
where:
number_of_retries is any positive integer
el980lb retry count 2
5
If no argument is specified or the specified argument is
invalid, the current value is displayed. Otherwise, the
new value is displayed.
N
ONFIGURING THE ET
W D
ARE RIVER