Error Messages - Ricoh M001 Service Manual

7. Press the "Escape" button several times, and use arrow key to select "3 End" to exit SP
Mode.
8. Press the "Menu" button.
9. Use the arrow key and select "List/Test Print".
10. Use the arrow key and select "Cardsave (ADD) or Cardsave (New).
11. To enable the newly configured settings, select "#" button and then press the "Escape"
button to exit the "List/Test Print" menu.
12. Send a job to the printer.
13. As soon as the printer receives the data, it will be stored on the SD card automatically
with no print output. Nothing is displayed on the screen indicating that a Card Save
operation was successful.
14. Press the "Suspend/Resume" button and then the "Escape" button to exit Card Save
mode.
15. Change the Bit Switch Settings back to the default 00000000.
16. Remove the SD card after main power switch is turned off.

Error Messages

Card Save error messages:
Init error: A card save process (i.e. card detection, change to kernel mode) failed to
initialize.
Card not found: Card cannot be detected in the slot.
No memory: Insufficient working memory to process the job.
Write error: Failed to write to the card.
Other error: An unknown error occurred.
If an error occurs, pressing "#Enter" will cause the device to discard the job and return to
the ready state.
SM 5-107
Card Save Function
M001