Ricoh M001 Service Manual page 97

Rev. 11/03/2009
866 SD card error 1: Confirmation
The machine detects an electronic license error in the application on the SD
card in the controller slot immediately after the machine is turned on. The
B
program on the SD card contains electronic confirmation license data. If the
program does not contain this license data, or if the result of the check
shows that the license data in the program on the SD card is incorrect, then
the checked program cannot execute and this SC code is displayed.
Program missing from the SD card
Download the correct program for the machine to the SD card
SD card error 2: SD card removed
The SD card in the boot slot
867 D
when the machine was turned on
was removed while the machine
was on.
SD card error 3: SC card access
An error occurred
868 D
while an SD card was
used.
Address book data error
Address book data on the hard disk
was detected as abnormal when it
B
was accessed from either the
870
operation panel or the network. The
address book data cannot be read
from the HDD or SD card where it is
SM
Insert the SD card, then turn the
machine off and on.
SD card not inserted correctly
SD card defective
Controller board defective
Note: If you want to try to reformat the SC
card, use SD Formatter Ver 1.1.
HDD defective.
Initialize the HDD with
SP5832. If this does not solve
the problem, replace the HDD
and initialize with SP5832.
Note: If you turn off the machine
4-17
Service Call Conditions
M001