Ricoh M001 Service Manual page 125

Rev. 3/30/2011
bit 3
[PS] PS Criteria
Change the number of PS criterion used by the PS interpreter to
determine whether a job is PS data or not.
Pattern3: includes most PS commands.
Pattern1: A small number of PS tags and headers
bit 4 Increase max number of the stored jobs
to 1000 jobs.
Enabled: Changes the maximum number of jobs that can be stored on the
HDD via Job Type settings to 1000. The default is 100.
bit 5 DFU
bit 6 Method for determining the image
rotation for the edge to bring on
Enabled: The image rotation will be performed as they were in the
specifications of older models for the binding of pages of mixed orientation
jobs. The old models are below:
-PCL-: Pre-04A models
bit 7 DFU
⇒
1001 Bit Switch
006 Bit Switch 6
Timing of the PJL Status ReadBack (JOB END) when printing
multiple collated copies.
This bitsw determines the timing of the PJL USTATUS JOB END sent
when multiple collated copies are being printed.
0 (default): JOB END is sent by the device to the client after the first copy
has completed printing. This causes the page counter to be incremented
after the first copy and then again at the end of the job.
1: JOB END is sent by the device to the client after the last copy has
finished printing. This causes the page counter to be incremented at the
end of each job.
SM
Printer Controller Service Mode
Pattern3
Disable
(100)
-
Disable
-
5-7
Pattern1
Enable
(1000)
-
Enable
-
M001