Ricoh M001 Service Manual page 104

Error Messages
1st/2nd Message
Hardware Problem, Ethernet
Hardware Problem, HDD
Hardware Problem, Option RAM
Hardware Problem, Parallel I/F
Hardware Problem, Printer Font
Hardware Problem, USB
Hardware Problem, Wireless
Board
Hardware Problem, Wireless
Card
Invalid Data, Power Off On
Invalid Password, Try again
M001
Problem/Solution
Machine detected an Ethernet error.
Replace controller board.
Machine identified a HDD Board error.
Replace HDD board.
Machine detected an optional RAM error.
Replace optional RAM.
Machine failed self-diagnostic test due to a loop back
error.
If parallel I/F is in use, replace the IEEE1284
interface board.
Problem with machine font file.
Replace print module.
Machine detected a USB I/F board error.
Replace the USB I/F board.
Access to the IEEE 802.11 a/g board was possible,
but an error has been detected.
Machine can access IEEE802.11 a/g board but an
error was detected.
Confirm that the board is installed correctly.
Machine failed to access IEEE 802.11a/g board.
Confirm that the board is installed correctly.
Machine has received spurious data.
Turn the printer off/on.
The invalid password was entered and Locked Print
or Saved File Print is not applicable.
Invalid password entered, Locked Print or Saved File
Print cannot apply.
Printer displays this message for 4 sec., then returns
4-24
Rev. 11/03/2009
SM