Selecting The Computer Display Resolution - RADVision SCOPIA XT5000 Series Administrator's Manual

Caution
Step 2

Selecting the Computer Display Resolution

Configure the computer display to one of the supported picture resolutions and refresh
frequencies.
Please notice the following system behavior when selecting the display resolution:
RADVISION | Administrator Guide for SCOPIA XT5000 Series Version 3.0
Make sure all units are switched off whenever connecting or disconnecting
devices.
•
For computers and laptops with a DVI out connector, connect the DVI cable to the DVI-I
socket of the XT Codec Unit and connect the other end of the cable to the computer.
Figure 2-1
•
For computers with a VGA output connector, use a DVI to VGA adapter.
a. Connect the DVI-VGA adapter to the DVI-IN socket of the XT Codec Unit.
b. Connect a VGA cable to the adapter. This cable is not supplied with the system.
c. Connect the VGA cable to the PC/Laptop VGA out socket.
Connect the computer audio to the XT Codec Unit.
•
Since audio input is not included in the DVI-I port to XT Codec Unit connection, establish
a separate audio connection from the computer's audio output port into the optical audio
input port of the XT Codec Unit.
•
You can also use an external analog-to-digital converter if necessary.
•
If you connect a camera to the DVI-I input, the system manages it as PC content.
•
When using XGA adapters, the system supports only 60Hz for 720p and 1080p formats.
Connecting a computer to SCOPIA XT Series
Maintenance Tasks | 10