Electronic Control Unit - Asko T7OO Series Service Manual

https://appliancetechmanuals.com

ELECTRONIC CONTROL UNIT

CH AN G I N G TH E ELECTRO N I C CH AN G I N G TH E ELECTRO N I C CH AN G I N G TH E ELECTRO N I C
CH AN G I N G TH E ELECTRO N I C CH AN G I N G TH E ELECTRO N I C
CO N TRO L U N I T ( ECU ) CO N TRO L U N I T ( ECU ) CO N TRO L U N I T ( ECU )
CO N TRO L U N I T ( ECU ) CO N TRO L U N I T ( ECU )
W ARN I N G W ARN I N G W ARN I N G W ARN I N G W ARN I N G
A grounded EMC wristband must be worn at all
times when working with electronic components
to prevent damaging them.
1. Remove the top cover (see page 23).
2. Remove the wiring from the integral cable
clamps in the electronic control unit holder.
3. Unclip the ECU from its holder.
ECU
P/N 8061856
4. Remove all the wiring.
5. Connect all the wiring to the new control unit.
W ARN I N G W ARN I N G W ARN I N G W ARN I N G W ARN I N G
Ensure that all wires and connection blocks are
connected correctly. Wires are marked with board
connections.
6. Snap the ECU into its holder.
7. Replace the top cover. Don't forget the two star
washers for the outer screws.
REM O V I N G TH E ELECTRO N I C REM O V I N G TH E ELECTRO N I C
REM O V I N G TH E ELECTRO N I C REM O V I N G TH E ELECTRO N I C REM O V I N G TH E ELECTRO N I C
CO N TRO L U N I T W I TH I TS H O LD ER CO N TRO L U N I T W I TH I TS H O LD ER CO N TRO L U N I T W I TH I TS H O LD ER
CO N TRO L U N I T W I TH I TS H O LD ER CO N TRO L U N I T W I TH I TS H O LD ER
1. Remove the top cover (see page 23).
2. Remove the control panel (see page 43).
3. Press in the two snap fasteners.
4. Slide the assembly sideways and remove it.
5. Remove the wiring.
ECU
P/N 8061856
Holder
P/N 8061921
REPLACI N G ELECTRO N I C CO N TRO L REPLACI N G ELECTRO N I C CO N TRO L REPLACI N G ELECTRO N I C CO N TRO L REPLACI N G ELECTRO N I C CO N TRO L REPLACI N G ELECTRO N I C CO N TRO L
U N I T AN D I TS H O LD ER U N I T AN D I TS H O LD ER
U N I T AN D I TS H O LD ER U N I T AN D I TS H O LD ER U N I T AN D I TS H O LD ER
6. Install the wiring in accordance with its labels.
7. Align the holder to the front rail. Fit the four
hooks into the square holes in the front rail.
8. Move the holder sideways so it snaps into place.
9. Replace the control panel.
10. Replace the top cover. Don't forget the two star
washers for the outer screws.
47