Rear Panel - Advantech UniGateway EH-2101W User Manual

UniGateway EH-2101W User Manual

Rear Panel

WAN port
(10BaseT)
DIP switches
Serial Port
Reset Button
PCMCIA slot
Power port (12V)
Figure 2: Rear Panel
Connect the DSL or Cable Modem here. If your modem came with a
cable, use the supplied cable. Otherwise, use a standard LAN cable.
Refer to the following table.
RS232 Serial Port. If you have an analog modem or ISDN TA,
connect it here.
This button has three (3) functions:
•
Reboot. When pressed and released, the UniGateway EH-
2101W will reboot (restart).
•
Diagnostic print-out. If held down for 3 seconds, a diagnostic
print-out will be sent to the attached printer.
•
Ensure the printer is ready.
•
Both Print LEDs will flash simultaneously during the diag-
nostic printing.
•
Clear All Data. This button can also be used to clear ALL data
and restore ALL settings to the factory default values.
To Clear All Data and restore the factory default values:
1. Power Off.
2. Hold the Reset Button down while you Power On.
3. Keep holding the Reset Button for a few seconds, until the RED
LED has flashed TWICE.
4. Release the Reset Button. The UniGateway EH-2101W is now
using the factory default values.
Insert the supplied Wireless PCMCIA card into this slot.
•
Ensure the power is OFF before inserting or removing the
PCMCIA Card.
•
Do not use any other PCMCIA Card.
Connect the supplied power adapter here.
6