Client Pcs - Using Dial-In - Advantech UniGateway EH-2101W User Manual

Client PCs - Using Dial-in

This section describes how to configure your PC to use the UniGateway EH-2101W's RAS
Dial-in feature.
To use the RAS Dial-in feature of the UniGateway EH-2101W:
•
An Analog Modem or ISDN TA must be connected to the Serial Port on the UniGateway
EH-2101W.
•
The UniGateway EH-2101W's Dial-in screen must be configured for Dial-in access, and
Dial-in Users must be created. See Chapter 7 - Dial-in for details.
•
A suitable Dial-up connection must be created on your PC, as described below.
Creating a Dial-in Connection in Windows
You can use the standard Windows Dial-up Networking software normally used for Internet
access. The procedure is as follows:
1. Ensure your modem is installed and working.
2. Select My Computer, then Dial-up Networking.
3. Click Make new Connection, and step through the Wizard.
4. Give this connection a suitable name.
5. Enter the area code and telephone number to connect to the UniGateway EH-2101W.
6. Continue the Wizard until completed.
7. The default values for this connection will work with the UniGateway EH-2101W's
default values. If necessary, you can adjust the Properties for the connection:
•
In the Dial-up Networking window, select the connection.
•
Right-click, and select Properties to see a screen like the one below.
Figure 38: Dial-up Networking Properties
68