Memory Installation; 2-3.1 To Install Ddr Sdram Module For This Mainboard; 2-3.2 To Remove A Dimm - SOLTEK SL-85DIV User Manual

85DIV / 85DIV-L

2-3 Memory Installation

How to tackle with the memory Modules:
• Make sure to unplug your power supply before adding or removing
memory module. Failure to do so may cause severe damage to both
your main board and the memory module.
• Pay attention to the orientation of the DIMM slots. Forcing a DIMM in
a socket improperly will damage the memory module and socket.
• Make sure you have the right type of memory module for your
mainboard.

2-3.1 To Install DDR SDRAM Module for this Mainboard :

• This mainboard only supports up to 2GB unbuffered DDR SDRAM,
with 2 DDR DIMM sockets on board. Do not insert other type of mod-
ules into these sockets.
• DDR DIMM socket has 184-pins and one notch. Insert a DDR SDRAM
vertically into the 184-pin socket with the notch matching the one in
the socket. Press the Module down in a gradual way until it surely
reaches the bottom and clicks straight up the two latches on the left
and right of the socket. If any one of the latches has not turned up
completely, you should unplug the module and press it down the
socket a bit more firmly.
184-Pin DIMM Notch Key Definitions (2.5V)
DRAM Key Position

2-3.2 To Remove a DIMM:

Press down the holding latches on both sides of socket and the module
will be released from the DIMM socket.
Voltage Key Position
2.5V
Module Latch
20