Fujitsu PRIMEQUEST 1000 Series Installation Manual page 99

PRIMEQUEST 1000 Series Installation Manual
CHAPTER 4 Installing the Operating System and Bundled Software
You can confirm a trap destination setting by using the standard trap of the SNMP service. For details, see
How to confirm a trap destination setting
5. Set the destinations of traps and e-mail via the MMB.
Make settings only as needed, such as for linkage with operations management software.
1. Set the destinations of SNMP traps via the MMB.
(See 7.5.2 Configuring
2. If Alarm E-Mail is to be configured, set the notification destination and filter.
(See 3.3.9 Configuring Alarm
6. Set the management LAN IP address.
Make this setting only if you need to change the management LAN IP address. For details, see
the management LAN IP
7. If the FC card is installed, install HBAnyware.
Remarks
For RHEL5.6 or later, replace HBAnyware with OneCommand Manager.
1. The libnl package is required to use HBAnyware.
Execute the following command to display the libnl package information, and confirm that libnl has
been installed:
# rpm -qi libnl
If libnl has not been installed, execute a search for the install medium of the distribution for the libnl
package, and execute the following command to install the package:
# rpm -ivh libnl-<version>-<release>.<arch>.rpm
Remark
<version>, <release>, and <arch> must be replaced with suitable character strings.
2. Download the driver and utility of MC-0JFC11 or MC-0JFC21 from the following URL:
http://jp.fujitsu.com/platform/server/primequest/download/
Note
The downloaded binary file has a description about the PRIMERGY, but the driver and utility can be
used for the PRIMEQUEST 1000 series.
3. Copy the downloaded file to an arbitrary directory of the PRIMEQUEST 1000 series, and then expand
it.
# tar xvzf F1010350.tar.gz
4. The following files are extracted:
in 6.3.3 Setting the destinations of traps from a
SNMP.)
E-Mail.)
address.
71
partition.
6.2.7 Setting
C122-E107-09EN